Petrophysical logs were the primary source of information used for constructing the bedrock topography. A suite of the common well logs (gamma, resistivity, spontaneous potential, density, neutron, sonic and calliper) were useful in making the pick for top of bedrock; however, the gamma and resistivity logs proved to be the most useful. The drift typically displays a lower gamma response and higher resistivity response than the underlying bedrock. Other sources of data were water well lithologs and mineral exploration drillholes.

Picking the bedrock surface was difficult in some areas where data were sparse. Many of the log traces were absent from the upper part of the hole because of surface casing. The depth of surface casing set in bedrock was used for an estimate of maximum drift thickness in places with few data. Conversely, some water wells and mineral drillholes did not penetrate deep enough to intersect the bedrock, so only a minimum drift thickness value could be used.